FOR 2003-2007 HONDA ACCORD PAIR CHROME HOUSING AMBER CORNER HEADLIGHT/LAMP SET

Description

Document
Features:
H
igh Beam Bulb:
9005/HB3
(
Bulbs are NOT included
)
Low Beam Bulb
:
9006/HB4
(
Bulbs are NOT included
)
Turn Signal Light:
1157A
(
Bulbs are NOT included
)
Side Marker Light:
1157A
(
Bulbs are NOT included
)
Smoke Housing Clear Lens Amber Reflector
Dimensions:25.00*24.61*8.46 inch
Weight:14.75 lb
SAE/DOT approved for street legal
Made By OEM Approved & ISO Certified Manufacturers With Materials That Meets OEM Requirements
Easy installation,  direct bolt-on, no modifications
Package Includes:
Pair of LH(Driver Side) & RH(Passenger Side) Headlight Headlamp
Compatible With:
Fit for 2003 2004 2005 2006 2007 Honda Accord coupe/Sedan
Installation Guide:
WARM TIPS
(How to install your headlight):
1.Undo the screws, clips, or retainer springs that hold the headlight in place.
2.Disconnect the wiring from the assembly.
3.Detach the headlight from the vehicle to replace it with a new one.
4.Fit in the new headlight assembly.
5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.
6.Reconnect the wiring that was unplugged from the assembly.
7.Put back the grille and other components that you removed. Seal them back into place.
8.Test the new assembly.
WARM TIPS
(How to adjust your headlight):
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.
1.
Find the adjustment screws.
Firstly, locate the adjustment screws on your vehicle.
2.
Adjust the headlight individually.
Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3.
Adjust the vertical field.
The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.
4.
Adjust the horizontal field.
The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5.
Test your results.
WE ACCEPT THESE PAYMENT METHODS
( 10% sales tax will be applied for orders shipped to Washington state by state law )
30 Days easy returns satisfaction guarantee.
Items to be returned must be in original factory condition.
Please enclose a note about item number and order id, your eBay ID and the reason of return.
On May-17-21 at 03:28:09 PDT, seller added the following information: